Remote-processing RPC-30 Manual de usuario descargar pdf (Pagina 13)

CHAPTER 3 SAVING PROGRAMS

RPC-30 Page 11

ERROR) and display the error message.

PREVENTING AUTORUN

When troubleshooting a program, it' s not always

convenient for an autoexecute file to r un. This is

especially true if the program has been configured to

ignore the < ESC> key.

To prevent autorun, remove jumper W3.

Later, if you wish to SAVE or LOAD a program,

reinstall this jumper. You may do so even if the power

is on and a program is running. Remember to discharge

any static electricity on you before putting the jumper

back on.

LOADING AN EEPROM PROGRAM

There are tim es when y ou may w ish to tempor arily

modify or otherwise test out a change to a program.

Since the program is loaded into RAM, modifications

can be made without affecting the program in EEPROM.

If you find out that modifications are not desirable or did

not work, you can restore the original program to RAM

using the LOAD command.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 37 38

Sin comentarios

Remote-processing RPC-30 Manual de usuario Pagina 13